黄色三极在线视频_国产在线手机免在线视频_无遮挡无码免费视频_思思久久99热这里精品66

YN-A750 Reactive Bonding Polymer Self-Adhesive Waterproof Membrane

YN-A750 Reactive Bonding Polymer Self-Adhesive Waterproof Membrane is a self-adhesive polymer membrane-based waterproof material made of polyester film as the reinforcing material, polymer-modified asphalt containing active additives as the coating material, and anti-stick isolation materials covering both the top and bottom surfaces.

During installation, this membrane employs the wet laying method, allowing the pressure-sensitive reactive adhesive of the membrane to crosslink and engage with the cement gel, thereby forming a fully adhered waterproof layer that prevents water leakage.

1. Strong Bonding Force: This material can bond with the concrete substrate through a synergistic combination of chemical and physical reactions.

2. Excellent Self-Healing and Local Self-Locking Water Resistance: The high-quality self-adhesive layer has good self-healing properties and can react with cement gel to form an interfacial sealing layer, preventing water leakage.

3. Good Elongation and Tensile Strength: It adapts to deformations in the structural substrate and can self-heal in case of damage (with hole diameters below 2mm).

4. Self-Locking at Leak Points: In the event of leakage, it can self-lock and prevent diffusion, facilitating maintenance.

5. Displacement Capability of Self-Adhesive Glue: It has good adaptability to deformations or cracks in local structures.

6. Flexible Material and Easy Installation: The material is flexible, and the installation process is simple, making it suitable for various complex substrate surfaces.

1. Waterproofing and impermeability for various underground projects, such as basements, subways, tunnels, and other waterproofing works;
2. Roof waterproofing for industrial and civil buildings;
3. Waterproofing works for underground garage roofs, rooftop gardens, and other similar projects;
4. Waterproofing works for fire protection ponds.

1. Base Layer Cleaning and Wetting: Use brooms, shovels, and other tools to clean dust and debris from the surface of the base layer. A dry base layer should be pre-wetted with water but should not have ponding.

2. Polymer Cement Mortar: When using polymer cement waterproof mortar, its thickness is generally 2mm-3mm. When applying the mortar, care should be taken to compact and smooth it out. At internal corners, a rounded corner with a radius of 50mm should be formed with cement mortar during base layer preparation. The width of the polymer cement mortar should be wider than the length of the waterproof membrane, with an additional width of 100mm-300mm on each short side of the membrane, and the flatness of the polymer cement mortar should be ensured.

3. Reinforcement of Detailed Nodes: Before laying large areas of waterproof membrane, reinforcement should be applied to detailed node areas as required by specifications.

4. Laying of Large Areas of Waterproof Membrane: Remove the release material on the lower surface of the waterproof membrane and lay it flat on the polymer cement mortar. Adjacent membranes should be laid in a parallel lap joint manner (generally, butt joints are not recommended). The width of the lap joint should be no less than 80mm.

5. Mortar Extraction and Air Ventilation: Use a wooden trowel or rubber plate to tap the upper surface of the membrane to vent air underneath and ensure tight bonding between the membrane and the polymer cement mortar.

6. Curing: After laying the waterproof membrane, it should be cured for 48 hours (the specific time depends on the ambient temperature; generally, higher temperatures require shorter curing times).